There is a lot of air in my brake lines, and my brakes are practically non-functional. I have read different techniques and orders on how to bleed air out of the brakes. My main question is...how do I bleed the rear brakes? They don't have a bleeder screw that I can see. Below is an image of what I see when I look at the rear brakes. My second question is...what is the proper technique/order of bleeding the brakes on my specific car? I am not using any sort of bleeding kit, and do not have an air compressor. I am doing it with an assistant pumping the brakes.

Thanks in advance.

 

see that rubber cap right above where the brake line screws into the back...remove rubber cap....bleeder valve.

 

hahahaha, yea what Scooby said