Brake Pin Boots
#1
Brake Pin Boots
I have torn one of my rear brake pin boots. I went to my Honda dealer and they cannot locate a part number for the pin boot. They can get any part of the entire rear brake assembly except the boot. I really find this hard to believe. They told me my only option was to get a new brake caliper assembly. I found that absurd. This is for a 1994 Civic Si. Anyone know the part number? I know Acura shared some components on the Integra. Attached is a link to the parts diagram. It is number 21 on the list. Pin Boot
#2
autozone!!
jus had to replace the ones on my teg not sure of part number but go to autozone n ask them for the caliper pin dust covers,should come in a brake hardware kit!! do the pins still slide in n out?? mine were rusted fast had to buy new caliper mounting brakets,pins n the dust covers good luck hope this helps a little,oh yeah make sure you put some synthetic(?) brake lube in side of the dust cover if you ever find them them!!
#3
Senior Member
Join Date: Feb 2003
Location: pittsburgh.
Posts: 1,863
Likes: 0
Received 0 Likes
on
0 Posts
Yeah if you can locate a caliper rebuild ket they will be included. I usually get them from rockauto.com but I'm sure they pretty easy to find. i would take the pins out and sand them down if they aren't clean (>400 grit)
#4
Went to Autozones website and low and behold Brake Caliper Bushing Thank you for your help.
Last edited by digger1978; 05-18-2007 at 11:39 AM.