Notices

Need stock d16z6 fuel pressure?

Thread Tools
 
Old Feb 20, 2007 | 03:19 PM
  #1  
hatchboi's Avatar
hatchboi
Thread Starter
Junior Member
 
Joined: Feb 2007
Posts: 8
Likes: 0
Default Need stock d16z6 fuel pressure?

need to set fuel to stock pressure. it at 32 psi right now.
Reply
Old Feb 20, 2007 | 06:43 PM
  #2  
Fuse's Avatar
Fuse
Senior Member
 
Joined: Oct 2006
Posts: 1,335
Likes: 1
Default

31 at idle fuel psi regulator vac hose on.40 vac hose off.Sound like you fuel psi is fine.
Do you have a specific problem you are trying to fix.

Last edited by Fuse; Feb 20, 2007 at 06:46 PM.
Reply
Old Feb 21, 2007 | 06:58 AM
  #3  
hatchboi's Avatar
hatchboi
Thread Starter
Junior Member
 
Joined: Feb 2007
Posts: 8
Likes: 0
Default

my car is not running right during hard acceleration
Reply
Old Feb 21, 2007 | 05:20 PM
  #4  
Fuse's Avatar
Fuse
Senior Member
 
Joined: Oct 2006
Posts: 1,335
Likes: 1
Default

Have you looked at your ignition system.Check you cap for cracks or burn marks.Check to see if you rotor is tight also look for burn marks.Test your spark plug wires 25k ohm max.Check your spark plug gap at .043 of an inch or look for rounded electrodes.You should be using non plat ngk plugs.I would also look at your ignition timing 16 degrees at idle(the red mark in the middle of the 3 marks not the solo white mark).

Some other things to look at is cam timing marks are rite or valve lash.

What is the long story did you change some thing,add some new mods,or did it just come out of the blue.Any check engine lights are you running a turbo or an air fuel control??

Last edited by Fuse; Feb 21, 2007 at 05:25 PM.
Reply




All times are GMT -8. The time now is 08:49 PM.