hey guys, im new here but not new to the forum aspect. Im trying to put calipers and the rotors off of a wrecked 97 integra onto my 98 hatch back. what my question is, can i just swap the hub out or is there a caliper re-mount kit that I can purchase. thanks

 

you;ll need the front knuckle/hub from the integra

 

so the hub will bolt right up? and thats all i need?

 

and were doing the rear disc conversion,

is there anything else besides the e-brake cables, proportioning valve, trailing arms, master cylinder and brake booster that we will need?

and will it all fit up?

 

Here's a few threads about disc brakes swaps....


http://honda-tech.com/zerothread?id=812062
http://honda-tech.com/zerothread?id=820484
http://honda-tech.com/zerothread?id=641639
http://honda-tech.com/zerothread?id=1513752
http://honda-tech.com/zerothread?id=641639
http://honda-tech.com/zerothread?id=1030365

 

Didn't search ahrd enough...
Step by step write up...
http://www.diynetwork.com/diy/ab_bra...275324,00.html

& more search results

https://www.honda-acura.net/forums/s...archid=1117506

 

thanks for the replies. i put on the hub, calipers rotors and lines for the front. today i just finished putting on the integra lower arms, and bolted his sway bar in place. i didnt have one, damn cx moel. and i even got his rear sway bar to fit up to my stock stuff. the holes were already there.

so here's the list.

Integra spindles, calipers, rotors, brake lines, lower control arms, front sway bar and rear sway bar.

I took the rear apart and im going to conver that this weekend.

Trailing arms, calipers, rotors, e-brake cables, booster and master cylinder.

on top of that Im swapping the B-18 in, full exhaust, alarm, wheels, and anything else I want from the teg all in the name of $500.

 

The proportioning valve is the same on all Civics. Rear disc or not. The only difference comes in if you have ABS or not. Check the P/N's on 99-00 Si and 96-00 CX's. They're the same.

 

i dont have abs, the integra does