Help Installing A Short Ram Intake
Junior Member
Joined: Jan 2006
Posts: 29
Likes: 0
not hard to do at all, you just take out the resonator the air filter box, and bolt the short ram right in there, it took about an hour to install my aem cold air intake, so the short ram should be similar, if not easier.
Honorary Moderator Alumni
Joined: Sep 1999
Posts: 8,735
Likes: 0
From: Someplace with cones=AUTO
Short ram you just take off the old stock intake box and tube, make sure you disconnect all the sensors. Install new intake and put back on the sensors. If you want to you can take out the resonator box which is located in the passenger side fenderwell area to free up some weight.
I took mine out by taking off the front bumper.
I took mine out by taking off the front bumper.
__________________
Sponsored by: KAM Racing Sports, Falken Tires, Progress Technology, Brady's High Performance, Taggart Performance Engineering, Rotora Brakes
Autocross is: 90% driver, 5% car, & 5% CRAZY MOJO!
Autocross Help Page
Sponsored by: KAM Racing Sports, Falken Tires, Progress Technology, Brady's High Performance, Taggart Performance Engineering, Rotora Brakes
Autocross is: 90% driver, 5% car, & 5% CRAZY MOJO!
Autocross Help Page
Member
Joined: Jun 2005
Posts: 219
Likes: 0
From: Phoenix, AZ
Should be a piece of cake if it is the short intake, if you still want to take out the resinator (just a plastic box to quiet down the intake of air) you can also do it by taking your right wheel off and the liner but you shouldn't have to. I did my cold air intake on my 95 in about 30 minutes.