ok im doin a motor change on my 94 civic and need to ask something if you were to pull the motor out slowly could you leave the CVs on the car and pop them out of the tranny without takin all that shit of the driver and passanger side ?

 

I assume you mean the axles. Yes, just remove the lower control arms and you'll have enough room to pull the axles out of the trans.

 

your better off just poping the axles out of the hub and the transmission then removing the engine. It doesn't take much time at all...I actually installed my axles today took no time at all...

The engine just went into the car after being built..winter project..

 

Sounds like it would be tough without messing up some stuff.

 

if you're going from a d series to a b series you're going to have to change the axles anyway.

 

takeing the axles out of the tranny should take about 1min a side just get a really long pry bar