how hard is it to build a set of itb's? i found a great deal on some carbs from a 97 cbr 900 and want to make sure i have a little info on what i'm doing.

 

to do it properly takes a lot of time and patience. I helped a friend make some and they were very nice and powerful. THe TPS stuff along with the map sensor is the most difficult part IMO.

also the clamp method is ghetto IMO. chop a manifold, and have it done correctly

 

how much would it cost to have done? if i was to do it by my self what would i need and is there someplace where i can find out how to do it.

 

I came accross this link about homemade ITB's. Dunno if it helps you or not.

http://www.homemadeturbo.com/tech_projects/itb/

 

thanks for the link, it was exactly what i was looking for.