Notices

need help with CERL codes...

Thread Tools
 
Old Aug 1, 2005 | 09:08 AM
  #1  
Joshcivic00's Avatar
Joshcivic00
Thread Starter
Senior Member
 
Joined: Jan 2005
Posts: 207
Likes: 0
Default need help with CERL codes...

I just did the self diagnostic and i am getting the codes 1(1 slow beep),2(2 slow beeps), and 7(7 slow beeps)! can anybody help me to figure out wha the problem is???i see code lists for other years but not for a 2000 Civic EX(the latest is a 1998 civic)are the lists the same??? if so it is showing that axygen sensor A(primary) and b is not working and that the TP sensor is not connected or something!

p.s. i just hooked up a greddy turbo kit with emanage and the car is wanting to bog in the low rpms and gets worse to were it like goes on safemode and it struggles to get to 3k rpms(only happend once) can anybody help???
Reply
Old Aug 1, 2005 | 09:29 AM
  #2  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

The lists are the same.

Your explanation isn't making sense. And where are you hearing beeps? The codes are measured in flashes. Long flash = 10, short flash = 1.

Example: 3 long, 5 short = code 35.
Reply
Old Aug 1, 2005 | 09:42 AM
  #3  
Joshcivic00's Avatar
Joshcivic00
Thread Starter
Senior Member
 
Joined: Jan 2005
Posts: 207
Likes: 0
Default

i said beeps but it was in flashes
Reply
Old Aug 1, 2005 | 09:48 AM
  #4  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

So, you have:

1 - Oxygen Sensor "A" (Primary) defective circuit or unplugged / defective sensor

2 - Oxygen Sensor "B" defective circuit or unplugged / defective sensor

70 - Automatic Transmission malfunction with the automatic transmission controls

I would bet that you wired up your eManage incorrectly.
Reply
Old Aug 1, 2005 | 10:07 AM
  #5  
Joshcivic00's Avatar
Joshcivic00
Thread Starter
Senior Member
 
Joined: Jan 2005
Posts: 207
Likes: 0
Default

well i know that my D4 light on the dash is flashing for some odd reason!
Reply
Old Aug 1, 2005 | 10:11 AM
  #6  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

Yup, you wired something very wrong. I'd turn the car off, disconnect the battery, and triple check your wiring. I'd have someone else do it actually. It's like reading a paper you wrote, you can easily miss the little mistakes where someone else will see them clearly because they have a fresh perspective.
Reply
Old Aug 1, 2005 | 10:32 AM
  #7  
Provocateur's Avatar
Provocateur
On permanent hiatus
 
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
Default

Originally Posted by westcoaststyle
I would bet that you wired up your eManage incorrectly.
That is my guess too. Either that, or you didn't set the Emanage correctly.
Reply
Old Aug 1, 2005 | 10:35 AM
  #8  
Joshcivic00's Avatar
Joshcivic00
Thread Starter
Senior Member
 
Joined: Jan 2005
Posts: 207
Likes: 0
Default

when u get the emanage that is specifically for a 99-00 civic ex, does it still need to be slightly tuned??should i just try and get it to a nearby shop and let them check the wiring out and stuff then???
Reply
Old Aug 1, 2005 | 10:42 AM
  #9  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

It will have the basic maps for you to drive the car. I wouldn't go crazy on the basemap.

You can take it to a shop to have them check it, but why pay for it? Just go over it until you see the mistake.
Reply




All times are GMT -8. The time now is 04:47 AM.