Fuel Managment for b16a
06-03-2005, 10:40 AM
#1
Registered User
Thread Starter
Join Date: Jun 2005
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Fuel Managment for b16a
I wan to put a EMS AEM Fuel Management system in my car along with injector, rail, filter and pump. I'm not sure how much of a different that would make with intake, headers, exhaust, and a full MSD ignition? Is it best only to put this on only if it is Turbo charged? If I get the EMS tunned can I gain a good amount of horsepower? Can i use this with stock inernals without any exta wear on them?
06-03-2005, 04:28 PM
#3
On permanent hiatus
Join Date: Jul 2004
Location: A forum with actual tech
Posts: 9,716
Likes: 0
Received 0 Likes
on
0 Posts
If it is a stock motor with minimal mods done to it, skip out on the EMS and all the fuel upgrades. When it comes time for increased fuel because of higher compression or forced induction, then you should think about it.
It looks like your motor is stock, so you won't benefit from the EMS. You may gain a few horsepower but not enough to justify the price.
It looks like your motor is stock, so you won't benefit from the EMS. You may gain a few horsepower but not enough to justify the price.