heres a link to the omni site http://www.omnipowerusa.com try emailing them or contact FunctionMotoring I believe they are an omnipower vendor.

 

i had a problem with the ball joint boot all torn up, ive got the older design of the skunk camber kit, i replaced them with oem boots and they seem to be holding up

btw the bushings on the camber kit on mine got all torn up after a few years but they can be replaced with energy suspension bushings, great upgrade, handling was more solid. gluck

 

Are the OEM ball joints you say from the upper control arm that you would normally take off when installing the Camber Kit? If so then how did you take out the joints from?