Spindle Nut -- Come off dammit
Thread Starter
Wal-Mart Shopper
Joined: Jun 2004
Posts: 341
Likes: 0
Spindle Nut -- Come off dammit
I can't get the spindle nut to come off 
How do I get this thing? Is there a tab or a pin I'm not seeing? I had someone hold the brakes on and the wheel still, and using a breaker bar I could not get it to come off.
How do I get this thing? Is there a tab or a pin I'm not seeing? I had someone hold the brakes on and the wheel still, and using a breaker bar I could not get it to come off.
ghey slow d16 modder
Joined: May 2002
Posts: 450
Likes: 0
From: fairfax, va
is it staked? you might have to unstake it. also...take the center caps off the wheels and put the wheels back on...try to take the nut off with the car on the ground. if all else fails, try to find a compressor/impact gun to use.
Registered User
Joined: Sep 2004
Posts: 205
Likes: 0
on my integra i had to use a breaker bar and a 4foot peice of iron pipe.. to break it.. i had socket wrenches on it i was jumpin on the summa bitch.. then i went to home depot and got a damn breaker bar and a 4 foot iron pipe... and it came loose
Thread Starter
Wal-Mart Shopper
Joined: Jun 2004
Posts: 341
Likes: 0
Finally I got it. I had a breaker bar with a 4 foot pipe that i found on it, pulled on the nut and the bar broke! Bought a new breaker bar, tried it again, and it broke loose after jumping on it. That was a bitch. I love Hondas 
