Saw a few threads about this Kit from Beaks, but I was curious as to whether anyone had any problems with clearance of the ITR sway bar with and aftermarket exhaust, in my case, a GReddy EVO. Or does everything fit ok?

Thanks

Adam

 

I have a custom 2.5" exhaust and I have no problems with my beaks kit/ITR rear sway bar.

 

i had itr rear sway benen rear lower tie bar. beaks kit for itr sway bar, and spacers from beaks for the rear low tie bar, and my apex dunk with custom piping banged against it, but i had the piping made before i put the rear sway bar in.

re did piping no problemo.

 

you should be fine with clearance...i have the same exhuast on my EK and theres a lot of room for the kit

 

k guys, thanks for the feedback. i'm probably going to get the quickswap kit to avoid headache of making sure i have all the misc parts needed.