Header gasket problems. :(
#1
I still like honda's. :-/
Thread Starter
Header gasket problems. :(
On my OBX header, it's a 2 piece, 4-2-1. The gasket for inbetween (header & downpipe) keeps going out. The one they sent me burned up 20 minutes after I put the header on. So i tried to find another gasket but noone has one that will fit, so I had to get a HUGE sheet of High Temp gasket from Napa and cut my own. But now the one I cut is leaking too. What else can i use?
#2
Originally Posted by dE.fUsEd
On my OBX header, it's a 2 piece, 4-2-1. The gasket for inbetween (header & downpipe) keeps going out. The one they sent me burned up 20 minutes after I put the header on. So i tried to find another gasket but noone has one that will fit, so I had to get a HUGE sheet of High Temp gasket from Napa and cut my own. But now the one I cut is leaking too. What else can i use?
#4
Originally Posted by dE.fUsEd
yuh i know but no other complaints. help would be a better reply. thnx.
#6
I still like honda's. :-/
Thread Starter
yah i got ya. pisses me off. i went to like 20 places an noone has a gasket thatll work.
EDit haha well i thought i sounded like a smart ass.
EDit haha well i thought i sounded like a smart ass.
#7
Originally Posted by dE.fUsEd
yah i got ya. pisses me off. i went to like 20 places an noone has a gasket thatll work.
EDit haha well i thought i sounded like a smart ass.
EDit haha well i thought i sounded like a smart ass.
#10
Originally Posted by igo4bmx
to totally eliminate the problem, maybe you should get the two pieces welded...
its not hard to install a one piece header anyways
its not hard to install a one piece header anyways
my 4-1 was a peice of cake to install