Inside Door Latch
#3
Senior Member
Join Date: Apr 2003
Location: Dallas, TX
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
the rod attatches to the the handle. There is just a hole in the plastic on the handle that the end of the rod slides into. I am unclear on what you are asking. You don't need to bend anything.
#4
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Indiana
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
The latch itself. You just have to pull the black pin, and then slide the latch off. Is that right?
However, I'm not sure how to get the lever off. This is what I'm calling the lever:
The backside the lever is held in by the rod. The rod is U bent. Can you just slide it off???
However, I'm not sure how to get the lever off. This is what I'm calling the lever:
The backside the lever is held in by the rod. The rod is U bent. Can you just slide it off???