Last weekend I completed a B16A2 swap into my 1997 Civic DX Coupe all by myself. Not bad considering I had absolutely no experience and had gotten the required info from online forums. From what I had read, the only wires to be added for this swap were for the knock sensor (red) and the vtec activation solenoid (green/yellow). I added both these wires and connected them to the proper pin on the ecu connector. While adding the vtec (green/yellow wire) I realized that there were two other wires that needed to be added to my harness. I believe these are also for the vtec since it's a two wire connector just underneath the vtec activation solenoid. I'm sure with all the experience on here... someone can help.
Thanks

Sev Fontaine
sevfontaine@hotmail.com