Will's right. Super easy. Here are some modified directions that I posted a while back in this post:

https://www.honda-acura.net/forums/s...&threadid=7273
--------------------------------------------------------------------------------
Originally posted by OSGP

1. Being a near total mechanical handicap, is it easy to install? Is it a DIY project or have to have a pro do it? Do I need to jack up the car?

2. Does it come with installation instruction?

3. Any tip or precaution for installation?

4. What type of tool do we need?

5. Approx time for installtion?
--------------------------------------------------------------------------------
1. It is easy to install. You can do it yourself. You need to jack the rear of the car up high enough to put jackstands under the car. Make sure to use wheel chocks up front. You don't need to remove the wheels. You basically remove the LCA pivot bolts, put the bar in place, then reinstall the LCA pivot bolts.

2. ...most don't come with installation instructions.

3. You might find it helpful to install at least one end piece first and then estimate the proper length before tightening everything down.

4. Ratchet; 14mm socket; torque wrench; jack with enough lift to get the car on jackstands; jackstands.

5. 30min. Since you're admitting to not being a super mechanic (at least you're honest), give yourself at least a couple hours just to be on the safe side. I honestly think you'll be done in no time as long as nothing goes wrong.

Good luck and I hope this helps.