Ok, I checked my car for:

#1 - The domelight doesn't turn on at all when the driver door is open/closed/whatever... HOWEVER, the door pin still works. I know this because when I leave the keys in the car and open the driver door, it makes a beeping sound, and when I close the driver door, the beeping sound goes away... Also, the passenger side door turns on the domelight and turns it off as usual. Why doesn't the driver side door do this?

I also need to hook up a clutch bypass thing (my remote start is built for manual trannies) and I am still a little confused. The way I want to hook it up is so that I would still need to step on the clutch to start the car with a key as normal. However, I only want to bypass it when I do remote start. Here are the best instructions I have found so far, but I still dont' fully understand them...

"top of your clutch peddle... there will be two switchs. One switch signals when the clutch is started to be pushed in, the other will tell when the clutch is all the way down. Now your car won't start w/o the clutch all the way down.. so that's the switch you need. find the 12v line (it's 12V's IIRC)... it should be constant. Now put your meter on the other wire(s), and find the one that shows 12v's with the clutch pushed all the way down. That's the one you want. Either you can just jumper the switch completely, or do what i did. Connect one wire from the switch to pin 30 on a relay (bosch style). Connect the other side of the clutch switch to pin 87. Now connect pin 85 to a constant 12v wire (you can use the one on the clutch for this) and connect pin 86 to the status output on your remote start (the one that goes ground when the remote start is ativated). By doing it this way, it only bypasses the clutch when you remote start it and not when someone hops in and tries to start it."

So does that require cutting the wire that shows 12v when the clutch is pressed down and hooking each side to a pin on the relay or just tapping into it??? If those instructions up there are correct, I can just run a constant 12v wire from anywhere (this is easy to find) to pin 85 and the PURPLE wire from the 6-pin main wire from the brain which is the output for the starter motor to pin 86. I am just confused about pins 30 and 87 and where I am suppose to tap or cut the wires (which am I suppose to do?)...

Hopefully someone can help me out on these issues??