I recently bought a Lynx 2000 (it's the newest version of an aladdin 2000). I installed it myself. Got a few general questions and a few Lynx 2000 specifics... So far the alarm and most features work great. However, I have 2 problems right now that I dunno how to fix. I have a 93 Honda Civic CX.

#1 - General Question - I hooked up the door trigger and domelight output according to page 15 of the install manual with a relay just like that (1st diagram, - output). I split the green/red (it was more of a teal/red) and ran the wires off of that to the relay and then from the relay to the brain. I am pretty sure it's the right wire as I checked the door pin on the passenger side and the dome light and they were both that same color (teal/red) as well. However, the driver side door pin is a different color. My problem is the alarm doesn't sense the driver side door at all. It detects the opening/closing of the passenger side door and pages it 100% fine. What am I doing wrong? Anyone know how to wire up the relay correctly because the damn manual shows TWO different things for the - output... =(

#2 - Lynx 2000 Specific Question - I can't get the AUX 1 2 3 to show up. When I hold down the A button, it just makes a short beep sound with a changing pitch). I have 2 door poppers (shaved door handles) and I need another aux output (i'm using the trunk popper for the driver side door) to get the passenger side door open. But no matter how I hook up the relay it won't work. It used to work flawlessly on my Viper 500+. The doors use a + output.

#3 - Where is the best place to mount the dual stage shock sensor to get a good reading all over the car?

#4 - Specific Question - Can addition sensors be added onto this system? It doesn't seem like the wiring allows for any... I want to add a tilt sensor. Would I just splice off the shock sensor wires or are there wires for it? Also are there any accessories for this alarm? It seems very basic. I was hoping for more features...

THANKS in advance....