You have to remove the front bumper cover. I think there is like 5-6 screws along the top when you open the hood, then you remove the plate. Inside each wheel well there is one screw, you have to pull back the black liner to get to them. If you have never removed the front bumper before you also have to get underneath the car and unscrew about 5-8 more screws that attach the bumper to the underliner. Make sure you dont confuse them and unscrew the factory chin spoiler in the front if you have one.

Remove the front bumper carefully from the car and set it aside where it wont fall over and scratch. Then you have 2 plates in front of each headlight held down with 2 10mm bolts on each side. Remove both of these plate and bolts.

Through the front support there is a hole next to each headlight allowing access to another 10mm bolt with a deep socket and extension. You have to remove these to remove the headlight assembly. It will be a nut that comes out, the bolt sticks up and will affect how you manuver the assembly out.

Remove the screw holding on your corner lamps. Then remove the 2 10mm bolts on top of the headlights holding them onto the car. Slide out the corner lamps. Slide out the headlight by pulling forward slightly then angle outward to get them out.

Install the harnesses as the instructions say, then reassemble.

When I reinstall the bumper cover I only use the screws on the top front and wheel wells. I dont put the screws back in underneath the car. It makes changing bulbs and access faster.