Originally posted by vashahonda
Hey, thanks guys!
I also have a problem inside the lens, the outside is good except for a few air bubles visible at the clear piece seam.
jschmid, appreciate your pix, it's a mess with salt here in NYC also 
h:
I guess you had better luck with you lights and you are right, you can't see it from certain angles and a few feet away so I guess I am keeping my lenses but only if they feet now!
And should I just put silicone all over the seams now or should I wait till I see any condensation inside?
Any way to seal area around bulb?
Thanks
No problem.
I never put any additional silicone on. Never had any fogging. I wouldn't recommend trying to seal around the bulb.
One tip for the install. 3 out of the four pieces fit great. One piece...when I tightened up the nuts in the back, the tail light would seat too far. I just used a couple rubber washers to space it back out where it should be, worked fine. I'd pick up a couple before you install them just in case you need a couple.