oh hell yeah!

I plugged her in and ran a few boards through her to make sure it ran right. Purrrrrs like a kitten. Bearings are quiet and adjustments move smoothly. I think I need to get a good blade angle gauge to make sure it is trued. I was out of town all weekend so no progress, but I will be around this weekend and will be stripping the fence rails and angle iron down to bare metal and re-painting it cause it is all chipped and surface rusted. Also need to resurface the table top, again surface rust. It's been sitting for like 5 years un-used in a garage. Also I need to track down belts for this thing as all three of them have seen better days.

is this the dust collector on HF? http://www.harborfreight.com/2-hp-in...tor-97869.html

How many dust collection points do you think this would support?