Hello i have a 98 civic ex coupe manual transmission, my car just stopped moving even while it was in gear would just sit there and rev up, so i purchased a Duralast Clutch Set from autozone and installed it following this tutorial, did not replace the flywheel though, after doing this my car's vtec wouldnt engage because i had accidentally broken the coolant temperature sensor so i then replaced that as well and everything was working great [= however after i drove it across town a week or two later it broke down again while i was driving same issue car goes into gear but angine just revs up wont move forward or reverse either, i did however notice when i was being pulled (truck and chain) [car was on for easy steering and a/c =)] my speedometer stayed at 0 the whole time this had not been happening before it broke down this time. i want to know if the vss could cause this or possibly not bleeding the clutch? any opinions would be great as i really rather not do the whole procedure all over again /=