SumAccordGuy94, thanks for the compliment. The wing is made by Value Sports. I had it imported from Japan through www.value-caraudio.com

I bought a variable load flasher from Autozone yesterday. They only had a mechanical 2 prong one. My car uses one electronic flasher for both the hazards and blinkers. The stock flasher has 3 prongs. Power, ground, and load. I rigged some wires to the variable load flasher and plugged it into the power and load slots. With key off, it has no power. When you hit the hazard switch, it gets power and the hazards work fine. With key on it automatically gets power without pressing anything. The hazards work fine with key on also, but the blinkers don't blink. They just stay on dim. Whats going on?

So if I open the stock flasher theres only one resistor in there? I dont want to replace the wrong one. I found a fully electronic flasher at www.libertek.com but its made to replace a 2 prong unit. I'm not sure about the Run-about either. BTW, the Jam Strait LEDs are great. They light up both my tails and front blinkers perfectly! I highly recommend them. Get the Hyper series though. They're blinding to look at.