There should be a 2 pin connector, theres a chance that it could be plugged in to a female connector, but its really just a holder, located either under the right side of your dash (under youre glove box) or behind the pass. side kickpanel, pull the connector out stick one end of the paperclip in each side of the connector( remember if its not a 2 pin, its not the right one.) after u do this then turn the igniton to the ON position with vehicle not running, the MIL light will then flash (a long flash=10, & a short flash=1, there will be a break of about 2 sec between codes. Although none of this will help you unless you can get a hold of a manual to find out what the code means.
Good Luck!!!:thumbup: