Well 15 minutes after my last post I got the call from Acura. They finally got me the correct head gasket. Because it was so hot out (At least for Oregon) I didn't really stop to take too many pictures.


Before I started any work for the day. Had my friend Q come give me a hand (Foot in pic)


So I had Q hold the head (He couldn't hold it still so its a little blurry) and I saw the the combustion chamber on the left looked worse than the others.


Just that cylinder


Got the head on and torqued down


Where I finished for today... I also installed new NKG V-power spark plugs. Was told that I should get a different heat range plug to run the higher compression pistons. Depending on my plans for tomorrow I will either work on it then or finish on Sunday. I'll take a video of the start up.