Made a lot of progress. The BMC issue killed any hopes of having a running Civic this week. The car is very close to finished. Just need to install the BMC and booster and we should be ready to go shortly after that.

Pics:

Front LCAs on!


GSR 24 mm front sway bar on as well. I somehow managed to find the poly bushings purchased nearly 5 years ago.


Upper Skank2 arm is on. With the cleaned up OEM pieces. The driver side took me nearly an hour to get in. Damn, what an annoyance.


New wheel bearings in. Left the original hubs in. Everyone said they were fine. New axle was installed as well. Tranny fluid in the tranny too!


Roll center adjuster. Really unique piece for this car.


Look a downward pointing LCA. You know what that means! Traction! Hopefully it still point down when it's under load.


Outer tie rod installed. New brake lines run. Dope sauce.


500 lbs springs in the front. 550 in the rear. It'll be set up for 2.5 degrees of negative camber in the front.


Still a mess, but now the wheel wells have something in them


ALMOST THERE!


Updates soon. Hopefully the s2k bmc and booster solve our problems.

BIG THANKS TO HATCHVX for helping me out A LOT this week!