Thread: Car AC Woes
View Single Post
Old Jul 30, 2009 | 08:21 PM
  #16  
AcuraLsSE's Avatar
AcuraLsSE
ASE Certified
 
Joined: Nov 2005
Posts: 1,428
Likes: 1
From: The 503
Default

Originally Posted by losiglow
Getting your AC ice cold isn't all that hard. The trick is finding the sweet spot with refrigerant pressure by not having either too little or too much refrigerant in the system.

It's normal for AC temps to get slightly higher when idling since heat dispersion is reduced when less air is flowing through the condenser. It shouldn't be too dramatic though, maybe a few degrees. Get a thermometer (little stick type that they sell at auto parts stores) and stick it in your cars vent. Unless the outside temp is 100+, the AC temp should be < 45F in most cases, even at idle. Also get a pressure gauge to check the refrigerant level, and find out what the pressure spec is for your car.

Refrigerantlevel should be checked when the car is warmed up, AC is cranked up to Max and has been on for 5 minutes or so. If the pressure is less than the spec, add a bit, but not too much. Adding too much will cause the compressors safety shutoff to activate due to too much pressure build up in the system. If you add refrigerant and notice the compressor kicking on and off within a few seconds time, you've likely overcharged the system. The compressor will kick on and off but not in a short time, especially if the AC's on max.

Also check for leaves or anything obstructing the radiator and condenser in the front of the car. This would limit the amount of heat the condenser could effectively release. It doesn't hurt to clean the condenser off occasionally with the hose or compressed air either.

I've got my AC running at 38F, 40F at idle. Fucking freezing cold, and that's with a 10 year old accord with all original equipment. AC problems, in my experience, are rarely due to something wrong with components, it's almost always something simple like under/over charged system or a blocked condenser.
Almost all true, you don't add the refrigerant to meet a pressure requirement. You add by the weight (in LBS) the system requires. The pressure in the system is determined by the amount of refrigerant and the outside temperature.The AC's compressor will shut off if pressure is too high, low, or the evaporator is starting to ice up.
Reply