Missing hood molding clips.

Not anymore


Of note: Only two bolts holding down bottom portion of box. top portion is missing screw, but not important enough to bother me. The bottom ones are more important because of the engine movement.


Top cover off - For some reason the K&N filter base is larger than stock, which is why I couldnt use the little spring/clamp at the end of the hose. Maybe I'm just too weaksauce.


When I modified the resonator box a couple weeks back, I noticed the bottom of the box was missing a rubber seal that isolated the intake air from the underhood compartment



Now its isolated - factory cold air ftw haha


Filter in - notice spring/clamp on intake hose



All done and bolted down