8) After some more cutting, it fit nicely into the reflector





9) Here's what it'll look like with the LED ring around it





10) I primed the shroud and painted it with chrome spray paint to match with the reflector










11) For fun, I also decided to mount these red LED's into the shroud. I quickly drilled some holes into the shorud and mounted them. I ended up applying another layer of paint after I drilled the holes.











12) Next I mounted the LED ring to the shroud





13) Then I mounted the shourd to the headlight reflector







14) Next you have to disassemble your front bumper. There is a screw in each wheel well, 7 plastic screws around the grill and 2 bolts under the bumper.





15) Remove the headlights. Each headlight has 4 bolts holding it.





16) I mounted the HID's to make sure they fit okay (and they did)





17) Then I took my aftermarket headlights apart by putting them in the oven for 375 degrees for 4 min. My reason for doing so was because I wanted to use their cover since it was cleaner and more clear than my stock ones. So I just swapped them from the aftermarket headlights to my stock headlights.











18) Here you can see the difference between both covers.





19) Mounting it is easy, there's only 1 secrew required for the aftermarket cover






20) Then I mounted it on to the headlights. Use any strong adhesive/glue to do this.





21) After I mounted the retrofitted headlights I had to do all the wiring which took a bit of time. I wired the red LEDs and the LED rings to the ignition wire that way they light up as soon as I start the car instead of the day time running lights (which are required in Canada)