Atf drain and fill the drain bolt is on bottom its the only one with a 3/8 drive square. The fill is on top of the trans it says atf. I think a drain and fill for a v6 is about 3.5 quarts or more.pic of the drain http://good-times.webshots.com/photo...03453110ZAnKLp

The bleed bolt for the radiator is a 14 mm with a little hole in it on the thermostat housing. It looks like you have a v6 so i do not think you have a bleed for the coolant, idle it with the radiator cap off heater on and front end jacked up to purge air add coolant as necessary. The drain for the radiator is a little white wing nut on the bottom of the radiator. Looks like you have a pic of it http://good-times.webshots.com/photo...03453110PMQbYO

P.S. has no drain bolt. You need to suck it out with a vacula. http://www.qualitywholesaletools.com...vac18-0079.jpg

http://good-times.webshots.com/photo...03453110lEelYV. One is a coolant block drain bolt the one far back with the little hole in it one is an oil pressure test port and the others are oil galley plugs. Looks like the rest are engine mount bolts and transmission bolts. You can drain your blocks coolant with the one in the back but you will need to bleed the system for a while.