Ok I tried searching, but I get nothing but retards who can't spell and I can't tell a word for a sentence or a paragraph. So I thought I'd start my own thread, being the new guy.

Ok now to the point, I have a 95' Si HB which is my DD as of right now, but I plan on building a motor for it in my spare time. I am shooting for high numbers 500+whp. Any opinions and help are greatly appreciated.

My plans are:

B18C1 Block
LS Crank
Honda Bearings
ARP Head Studs
ARP Rod Bolts
ARP Main Studs
OEM ITR Oil Pump
Eagle Rods
9:1 SRP Pistons
C5 head or C1 head
Sleeved
MSD 6-BTM
.030 Over Bore
Home Port Job

Now what size valves and what valve train to go with? What is a good engine management? Windage Tray? Clutch? Is a lightweight flywheel a good idea? What intake? What size injectors? Also I have an SC61 I can play with, a couple Holset's, and a Turbonetics 62-1.. However what would be a good set-up with a turbo, and what's a good turbo mani? What are good rings for this type of power? Also don't reply if you don't know what you're talking about.

Thanks