sweet, Even a valve job wont effect the emission much right? Any suggestions,comments, etc on my setup?
b18c1 with rebuilt bottom end with USDM type r pistons, port and polish head along with 3 angle valve job, skunk2 stage 1 cams, skunk2 retainers,valve springs,skunk2 IM, compression ratio 10.8:1
Should i go with a higher CR? or is 10.8:1 enough? CTR cams or skunk2 stage1 or any others reccomended?
Or Should i go with a complete type r head setup, with skunk2 cams,retainers,valves springs??? thanks