Originally Posted by
88'CRX
k looking at the diagrams there it seems that i would connect the + of one voice coil to the- of the other voice coil on the same sub... is that true.. i didnt think u were suppose to hook up + to -
its correct..... well it depends on the specs of both
a 4ohm dvc can be wired for 2 or 8 ohms
a 2ohm dvc can be wired for 1 or 4 ohms.
the amp is 150 x 2 @ 4 ohms... and the subs are dual 2 ohms.... so the coils are wired in series ( + of one to the - of the other )
edit: i found different info on 2 sites
if you go the stereo route....
150 watts RMS x 2 at 4 ohms (230 watts x 2 at 2 ohms stable) ... youre better of getting 4ohm dvc and wiring them for 2 ohms each.
if you go the mono route...
460 watts RMS x 1 bridged output at 4 ohms... the 2 ohm dvcs will be wired for 4ohm each, then in parallel for a final 2 ohms.