Originally Posted by
Fuse
I don't know its hard to diag a car over a computer screen.
Try lifting the cars front end(You got a jack).Place some jack stands under it and run it.Thy make stethoscopes for cars you can pick on up for like 15$ at a good automotive store.Place the stethoscope at the bearings,diff,and the intermediate shaft bearing(your car may not have an intermediate bearing).If it anything sounds like grinding rocks thats the problem component.
I would still say its the wheel bearings or the diff bearings.
A bad axle usually is only loud on sharp turns(unless it is about to come apart).
That sounds like my only option to figure out exactly what's going on. I knew this was more unique than alot of the other posts I've seen so far. So, I'll do what I can to diagnose where exactly this is at. Thanks for the help so far. One other question - Have you seen any write ups around for best things to replace when you have you're tranny out and open? I'd like to go ahead and do full service on my tran if I pull this out. Thanks