look for the label on your ecu, if it isn't there, then you have to unscrew the cover and look at the label on the connector for an ecu model...

check out http://hybrid.honda-perf.org/tech/index.html
they have some at the bottom

im sorry, there is usually only one wire to route, but you should check on three...

the vtec solenoid wire that i was talking about needs to go to pin a4 on your ecu the wire coming off of the ecu connector is yellow and green...

the vtec ground wire is black and it just needs to be bolted to the chassis or spliced into a ground...

look on the passenger side wiring harness for the vtec oil pressure sensor wire, its blue and you need to run it to pin d6 on your ecu connector...

look at this picture of the ecu connector http://www.jspecautosports.com/page.aspx?page_id=17