nevermind, found a guide on autozone

1.

Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
2.

Remove the dashboard lower cover and knee bolster.
3.

Remove the upper and lower column covers.

Click image to see an enlarged view
Fig. 3: The upper and lower column covers must be removed to access the switch

4.

Remove the two screws securing either the headlight or wiper switch to the housing and slide the switch outward. Be advised these mounting screws are tight; use a screwdriver of the correct size to avoid damaging the screw heads. Remove the steering wheel if additional access to the screws is needed.
5.

Unplug the wiring connector.
6.

Installation is the reverse of removal. Make certain all wiring connections are tight and the harnesses are secured in place. If applicable, be sure to enable the SRS.