Yes, you can do it yourself. their are plastic clips that attach to the door panel then go into the door sheet metal. After you remove the machine screws that are in the storage pochet(small one in the armrest) you'll see a litttle plastic cover (1/2" X 3/8 in). take a flat head screw driver and pry that off. take out that screw. 10mm or phillips. take your fingers and get them behind the door panel(use the tip of a flat head to pry so u can get your fingertips in there) at the bottom of the door/door panel. pull hard! work your way out. then there is the plastic triangle where the side mirror is, grab it and carefully yank it off. the top of the door panel has a lip where the window seal is, that lip sits on top of the door sheet metal. Grabbing the bottom of the door panel, apply pressure upwards and rock side to side. when off, you'll have access to the door panel wire harness. take that off. Reply back for an easy way to modify the factory speaker mount/jig.