Originally Posted by deboda954
try bridging it. there should be indicators on your amp where you connect your subs. something like:
Channel1 Channel2
(+)__(-)..(+)__(-)
.^-------------^
.......BRIDGE.......
connect them here. if it doesn't say, look in the manual. this will make your sub a LOT louder, just be careful not to blow it!
That wont work! he,s not getting any SQ somthing is not set right may be as silly as mentioned above with gain.
You could use a 1200 watt amp 2 channel (600 watt per channel)mono amp, hook it up two a 600watt sub. Pending the make of the amp it might produce around 350-450 rms(per channel). The sub being a single voice coil should hit hard if the subs any good no matter what. Meaning bridgein it wont do squat for him till its wired/and amps setting are right.
