Originally Posted by TheOtherDave™
• Ditch the test pipe.
• If your state will let you, run a high-flow cat instead, matched to your header diameter.
• Once an operational catalytic converter has been fitted and both O2 sensors are plugged in and operational, pull the + (positive terminal) battery connector and let the car sit for 10 minutes.
IMPORTANT: If you have an OEM radio installed, be sure you have the Anti-Theft code in hand BEFORE DISCONNECTING THE BATTERY.
• Once 10 minutes have elapsed, reconnect the battery and go for a drive.
If the Check Engine Light comes back on during your drive, retrieve the code using the directions in our FAQ thread. Then come back to us for assistance.
---
And ignore your friend's advice.
A wideband oxygen sensor would not fix the problem on it's own.
The OBD-II networks expect to see a drastic reduction in post-catalytic converter o^2 content. When both narrow-band sensors report the same level of o^2, the ECU figures that either a) the cat is not performing properly or b) it isn't there at all.
Thanks....
A weld between my resonator and pipe broke last night so I welded it. While reinstalling the pipe, I noticed the inside of the convertor and wondered, "Hmmm, I wonder if I can punch out the inside of the convertor to get better gas mileage?" Then I noticed the sensor at the front and rea r of the convertor and I assumed that the computer would compare the results of the 2 sensors. Thus, punching out the inside of the convertor would not work. So I got online and found your comment that verified my theory.
Thanks once again Dave!!!
Kevin