Step 13.

put out a piece of the PC bord to make a socket connection like you would have from your OEM bulb. PC bord just happends to have about same thickness for this app, acclent.


Step 14.

Trim the little piece, and test fit it. it will be a tight fit, but that just means more secure connection.


Step 15.

Making a connection..I hope my MS-Paint work explained it well enough.
basically, you are making a replica of your OEM bulb to make a connection


Step 16.

test fit it agian...this will be harder to fit into before you wired up the wires.
so you don't have to worry about "what if the wire connection gets loose" situation.


Step 17.

Fun of this DIY..soldering!
and agian, it's entirely up to you to make decision how to wire up your circutes.
just remember agian that each LED should have resistor for it's own. not sharing one resistor in a serise. I used 3 leds, so I also used 3 resistors.


Step 18.

solder..solder..solder..ooh..solder..the smell of that rasin..ooh...yuck!