Well, I just finished installing the head back on my car. I had new guides put on, and valves lapped in and had the head resurfaced. I installed the whole valvetrain, and then installed the head and everything. I lined it all up for timeing and everything, tightened timing belt. I did it all. If there is something you think I am missing let me know. Anywayz, I went to finally start the car, after priming it, and I kept cranking it, and the a CEL kicked on. The CEL was a code 8, which is a TDC Code. What do I need to do to fix this code, so it will start, I already tried reseting the ECU and all of that. I have solved other problems in the past, but I just can't seem to figure this one out, in that, I didnt think B16a1's had a TDC/Crank Sensor. I know other people have ran into this problem out there, jsut let me know so I can finish my project. THANX