I ordered a replacement steering gear bellows (rubber boot) for my '91 CRX and found that it doesn't fit. The length is ok but the hole sizes at both ends are wrong. They're much too small for my rack. I'm not sure if the part is incorrect or if my rack is out of a different car.

I'm doing a few suspension mods and I'm slowly sorting out which is CRX and which is Teg. So far:
b16a - Teg
axles - Teg
knuckle - Teg
tie rod ends - CRX
damper fork - CRX
lower control arm - CRX
upper control arm - ?? (Energy Suspension bushing for CRX didn't fit)

My question is - can it be possible that my steering gear is from an Integra or are they not even interchangeable with a CRX's? The torn bellows that I took off had about a 1.4" hole on the inner side and a .5" hole at the tie rod end.