Don't know if I am allowed to post this...


FRONT DOOR WINDOW COMES OUT OF CHANNEL
TECHNICAL SERVICE BULLETIN
Reference Number(s): 95-040

FRONT WINDOW COMES OUT OF THE CHANNEL

Model: 1994-96 Honda Accord Coupe

Category: Body

Bulletin No.: 95-040

Date: October 16, 1995
SYMPTOM

The front door glass comes out of the run channel.
PROBABLE CAUSE

Misadjustment of the front channel.
CORRECTIVE ACTION

Adjust the front channel. Replace the run channel and mirror gasket if they have been damaged by the glass.

1. Remove the door trim panel as described in steps 1 thru 9 on page 20-4 of the Service Manual Supplement.
2. Inspect the door mirror gasket for tears or cuts. Replace the gasket if it is damaged, see PARTS INFORMATION .
3. Inspect the run channel for tears or cuts caused by the glass coming out. Replace the run channel if it is damaged.

NOTE: You DO NOT have to loosen any of the window regulator mounting bolts or perform any glass adjustments when replacing the run channel.
4. Raise the window fully. Loosen the two front channel mounting bolts. See Fig. 1 . Move (without forcing) the channel rearward to increase its overlap with the glass. Tighten the mounting bolts to 8 N.m (0.8 kg-m, 6 ft-lb).
5. Raise and lower the window several times to check for binding or slow operation. If necessary, readjust the front channel.
6. Lower the window. Replace the two glass mounting bolts with the new bolts listed under PARTS INFORMATION . Apply DC-111 grease to the O-rings on the mounting bolts before installing them. See Fig. 2 .
7. Reinstall the door rim panel.

Fig. 1: Front Channel Bolt Location

Fig. 2: Glass Mounting Bolt Locations
PARTS INFORMATION

PARTS INFORMATION
Description P/N Honda Code
Door mirror gasket, Right LX and EX 76205-SV2-A25 4916375
Door mirror gasket, Left LX and EX 76205-SV2-A25 4916383
Door mirror gasket, DX Right 76205-SV2-A11 4916391
Door mirror gasket, DX Left 76205-SV2-A11 4916409
Window glass mounting bolt (two required) 90112-SV2-000 4919973
WARRANTY INFORMATION
IN WARRANTY

The normal warranty applies.
OUT OF WARRANTY

Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.

WARRANTY INFORMATION
Operation Number Description Template ID
826001 Left 95-040A
827001 Right 95-040B

Flat Rate Time: 0.5 hour per window

Failed Part: P/N 76255-SV2-A25, H/C 4916383

Defect Code: 021

Contention Code: A01









I thought I had the same problem is you, but I replaced the entire regulator/motor assembly and it did not fix it. Then I noticed there was a gap in between the window and trim. I looked up some TSBs on my car and found this 1. I still haven't fixed it yet but I might give it a shot in a week or so. If you want the pictures email me or pm me. I will be getting them later for personal use anyways.