Originally Posted by 90CvcDX
that may explain why a DX wheel bearing fit in my STD knuckle, i have Si knuckles with everything on them sitting in my basement i never put them on because i was told that i'd need an si tranny and dx or si axles to go with it, but if ur saying i can keep my std 4 speed tranny and just swap out the knuckles than that solves my problems
not quite sure what you are saying you want to do - if you want to swap out your STD knuckles/hubs for the Si ones and keep your 4 speed, you wil need DX/Si axles - all of the knuckles themselves, except for the EX, are the same - what is different is the hub portion that has the splines for the axles - all of the bearings are the same, even EX - the reason every one swaps the knuckles and hubs together is that is just easier to swap the whole thing instead of disassembling it to swap hubs - if you want the Si brakes, they just bolt on to your STD knuckles - you will need to use the STD brake hoses, because the little brackets on the hoses are different, where they bolt to the strut, from the DX/Si