Well it was a rush job because I had just done my swap and was rolling around with an open header. They were about to close, so they were just going to make something so the header and cat would seal, but then my old exhaust fell apart. So they just did a rush job that was basically one piece after the cat...no resonator, muffler welded on.

There were no spring-loaded bolts from the cat to header so the exhaust just broke after the cat because it was rusted out and had no slack without the spring-loaded bolts. I had to get a whole new cat-back today, and they could only do stock size (my custom was 2.25) because they apparently can't do any bending or welding. I just went with it because I needed it done, and the 2.25 was a little loud for my taste. At least I'm back to full sleeper status now

Ok, enough of the non-TF. Yeah, the buble packaging looks really cool, and it's a lot smaller than I thought it would be. I had whole case from BBTS, but some of the packaging was still dented on the bottom. I don't really care because I will most likely open them all. I have the BT versions of all them for my MISB pleasure.