Part II:
With the airbag cover removed disconnect all factory wire connections. Remove factory wheel lock nut. Now with a steering wheel puller remove the stock wheel.

(pic with steering wheel puller on the wheel: )


(wheel is off the column: )


Now transfer all hardware from the old wheel to the new leather one. When placing the cruise and volume switches back on the new wheel test fit the airbag and make sure gap for switches is as before. If not, loosen screws and readjust. If using a cast aluminum leather wheel you will need to get new screws to hold the rubber balancer weight on top as the stock steel wheel’s will not fit with factory screws.

Now reinstall the new wheel by centering it on the shaft and tightening down the lock screw to 40-45 ft-lbs. Reinstall wire clips. Reinstall airbag in reverse order. Be sure to hook up horn and airbag connections.

Check fit and finish. When satisfied reconnect battery.

Some finished pics
Mine:



MrChad's:



I know every step is not pictured but you get the idea

[Typs-S wheels will fit on Preludes but requires the purchase of Gen 6 airbags and cruise control switch. As stock Lude parts won’t fit the new wheel. All other wires are the same and will direct plug. This applies to Gen 5 Accords (CL’s) as well.]

(Note: If you are unfamiliar with airbags and such do not attempt this yourself. I assume no responsibility for your inability to do this install should something go wrong. Don’t call me when you mess it up. This is a disclaimer.)