Back when I did the conversion in my car, it was pretty easy. I used a set of 9005 Sylvania Silverstars. All you have to do is first break off/sand down the plastic grooves in the new bulbs to make them look like the inside of the 9006's plug. Then you have to snap off/cut off half of one of the tabs on the outside of the plastic plug housing, so its not as wide. Then take the rubber seal off the old (9006) bulb and it put it on the new (9005) bulb. (You will then have two rubber seals on the 9005 bulb.) Make sure you wear latex gloves or something similar so you don't get any oil from your hands on the bulbs. That's all. Sorry, no pics. But be forewarned. I had to replace 2 silverstar bulbs in less than 6 months because they randomly burned out. It looked really good, but it can be a pain when you have to go and buy another $20 bulb and do the process over again. Road signs especially seemed more noticeable at night. Good luck.