View Single Post
Old Jul 1, 2005 | 12:54 PM
  #1  
2005300C's Avatar
2005300C
Registered User
 
Joined: Jul 2005
Posts: 5
Likes: 0
Default F/S 00 Boosted ITR

Whats up everyone im NEW to this forum.

I have a 00 ITR yellow for sale im asking $25,000 obo (no lowballs)

2000 Acura Integra Type R, completely built turbo car. Engine has approx 500 miles since complete rebuild. Willing to work out a trade deal, clean title is in hand. Car has never been in an accident of any kind and is in mint condition. Below is a list of mods that are currently on the car, current setup is capable of 500 whp by slightly increasing the boost. I am looking to do a K swap in a hatch that is the reason im selling this car. If you are intrested you can email me at mohamad.ganchi@cingualr.com

Dyno Sheet from AMS, tuned to 410 whp at 18lb of boost

Specs

Jun Cam Gears, dual valve springs

Type R cams

New stock type R valves

Golden Eagle sleeved block, bored to 83mm, balanced and blueprinted bottom end 1.9L. Copper o-ringed combustion chambers

Arias Pistons, 9.5:1 compression ratio

Eagle connecting rods

Exedy 3 puck clutch and 8 lb flywheel

AEM ecu with wideband O2 sensor and 3bar GM map sensor, tuned by AMS of Chicago

Precision 780 CC/min fuel injectors

Custom goodridge braided oil feed and return lines for turbo

Moroso Oil Pan

Endyn Breather Kit

MSD ignition and blaster coil

Cometic Head gasket, .010" thicker than stock

South Florida Performance Tubular Turbo Manifold

HKS wastegate, set to 14lbs of boost

Thermal 3" exhaust

Apexi Full bodied coilovers

Greddy Profec B boost controller and turbo timer

Greddy Type S blow off valve

JDM "Honda" red valve cover

Autometer oil pressure, water temp, boost, and fuel pressure gages

AEM wideband O2 sensor gage

AEM fuel pressure regulator and fuel filter

Spoon Thermostat (colder openning temp)

C & R full length radiator with a SPAL slim fan

Precision T3/T4 turbo with 70AR and 60 series trim

Greddy front mount intercooler

Golden eagle fuel rail and oil distribution block

JDM OEM type R front end conversion

C West front lip

Recaro SRD seats with red stiching

Skunk 2 rear upper strut bar

Project U brake pads and slotted/drilled rotors (Front only)

Goodridge braided brake line

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]