Originally Posted by mono
what is a good brand of cams? i was looking skunk2 stage2 withe retainers, springs and pulleys. i still want to keep factory idel. and what would you reckon i should lift my rpm to.
and what is a good make of headder. and are lightened flywheel worth it.
Skunk2 stage 2 cams should be a nice setup along with some stiffer springs to handle the higher lift they provide. Idle may be a little lopey, not not too bad. Change the rev limit to whenever power gains drop. If you make power up to 9k but not any more, keep the rev limit at 9k. You will have to get a VAFC to tune them on a dyno, so don't forget that.
I don't know much about the H22, so I couldn't recommend a good header. I am sure a search through this forum will yield a good idea.