So it started as a small problem where trans oil was slowly dripping on the garage floor. It was leaking from the seal where the input shaft from the gear shifter goes in. I removed the old seal which sucked due a stubborn rooll pin which holds the linkage to the tranny. I had to bang on it pretty hard to get it out. Other then that all went well. Refilling trans fluid suxs as well. I back of my ramps and into my sloped garage and all is ok. I clean up and then go to test drive it and it won't go in first or 2nd. No grinding no nothing just won't go in. Any ideas? I tried moving forward soem in 3rd, and easing outo n the clutch as I tried to shift. Nothing liek that works.

Helppppp